GPSR Adjustable Triple Clamps
Our billet triple clamps have replaceable offsets that allow adjustment of the steering stem by 1 mm increments from -6mm to +6mm. Offsets are marked for easy identification and have a raised edge for easy removal. Lower triple tree features a ‘split’ clamping area allowing proper torqueing of the two bolts on the first try – you no longer need to go back and forth several times like a standard ‘non-split’ clamping area. 7/8” and 1” handlebar clamps available in various heights and pull backs.
Split Clamping Areas
It’s the details that make the difference, like our exclusive ‘Split’ clamp design.
It’s annoying when tightening the lower clamp and you have to keep going back and forth between the two bolts to get them properly torqued. Our split clamp allows you to tighten each bolt individually, so you can tighten it once and know it is right.
Instant Stripped Thread Repair
Trying to repair a stripped thread is never fun, but the GPSR triple clamps can be fixed in seconds.
By using 3D modeling, we have designed our threaded holes to carefully match the center point of the machined webbing under our clamps. If you strip a thread, simply use a longer bolt and one of our dowel-shaped nuts and you are back on the track in no time.
Replaceable offsets allow 1mm adjustments from -6mm to +6mm.
Offsets with Raised Edges
Flush offsets might look nice, but our raised edges are a lot easier to remove and change.
Standard sizes are 195mm wide with adjustable offset from 54mm to 66mm. Sold complete with choice of handlebar clamp 7 pair of offsets.
- 195mm wide for 35mm forks
- 195mm wide for 43mm forks
Triple Clamps for wider, narrower, and special forks are also available.
Sold complete with choice of handlebar clamp and 7 pair of offsets.
- Ohlins 56mm OD
We also make custom sizes. Contact us with your requests. Sold complete with choice of handlebar clamp and 7 pair of offsets.
Use with longer bolts for an instant repair for stripped threads. See Features tab for more details.
Set of 2.
7 sizes are available from 0mm to 6 mm in 1 mm increments. They can be installed with the offset forward or backward for a total adjustment of -6mm to +6mm. Sold in pairs.
Height measurements taken from top of triple clamp to center of handlebar. Available for standard 7/8” and ProTaper 1.125” diameter handlebars. Sold in sets, complete with bolts.
- Short: 1.0 inch high
- Tall: 1.5 inches high
- Bar Back: 1.25 inches high, 0.5 inches back
Heights measured from top of triple clamp to center of handlebars